Q – How does the Label Lifter™ actually work?

A – The Label Lifter™ actually works by penetrating the paper label with a specially formulated adhesive to lift the printed surface off the label onto the clear plastic.

Q – How does the Bottle Wrap™ work?

A – There is an adhesive covering one entire side of the Bottle Wrap™. This special adhesive only sticks to itself. You wrap it around a bottle and secure it by pressing the adhesive sides together to conceal its identity. And by pleating the top just enough to close the neck it will not reveal the bottle shape either.

Q - Why should the label go under water before using the Label Lifter™?

A – Ten to twenty seconds under warm water will:

1. allow for a better penetration of the Label Lifters'™ adhesive into the label being removed
2. soften and warm the glue for easier removal
3. ensure that the label and bottle are clean to begin (so that you do not laminate dirt or dust with your label!)

Q – Why does the occasional label seem more stubborn to remove than most other labels?

A – There are several possibilities ranging from how the label on the bottle has been applied and the amount of glue that was used, to the age of the bottle. Also the extra glossy labels may require additional time under warm running water – when the edges of the label start to ripple slightly, it’s ready for removal. Also, check that it is a paper label! Some plastic labels can be deceiving.

Q – Where can I find your products in my area?

A – Check your favourite wine shop, wine accessories shop, culinary/kitchen shop. You may contact us with the city that you live in and we’ll let you know who in your area carries VNA products.

Q – Will the label still come off if I over-soaked it or saturated it?

A – Yes, however, when over-soaking has occurred, the label is too wet for the adhesive to stick to it. The label will need some time to air dry before applying the Label Lifter™ for removal.

Q – Will the Label Lifter™ work on plastic labels?

A – Yes and No. Label Lifters™ can be used on plastic labels to improve removal, reduce stretching, tearing and deforming. You will need to pull up an edge first to get it started since the adhesive can not penetrate the plastic.

Q – Can you use the Label Lifter™ without putting the bottle under water?

A – Yes, however your success rate is greatly improved by using warm water for about 10-20 seconds. The water assists with softening the glue and cleaning the surface of the label.

Q – Can you add more pages to the Adventures with… Wine™ Journal Collection?

A – Yes! This is one of the reasons Adventures with … Wine™ is so versatile. Just inquire at the outlet where you purchased the Journal or check our ordering menu for various options.


Q - Can you use the Label Lifter™ on other things?

A - Label Lifters™ can be used to remove paper labels from just about anything – liquor/spirits bottles, jam jars, sauces, etc. Label Lifters™ also laminate photos, certificates, recipes and anything else you want to secure into your Adventures with … Wine™ Journal Collection.

**Please Note**If you have some favourite places to shop and would like them to carry Adventures With Wine products, please contact us with their name, address and number.

As our way of saying ‘Thank You’ for your referrals, we would be pleased to send you a complimentary gift of Label Lifters™, a 24 pack, valued at $13.00!

Q – Can you give any recommendations for easing the removal of the occasional tough label?

A – Yes, here are several options:

• If, once the Label Lifter™ has been applied, the label does not come away in one piece, then re-apply the Label Lifter™ and begin removing it again from the other side.
• If some parts of the label have not come away when you have removed the label, put the remaining label that is on the bottle, under water again for only a few seconds, pat it dry and reapply the Label Lifter™ to line up in place and continue as directed.
• Fill the bottle with hot water to soften the glue from the inside too.
• Use a second Label Lifter™ to lift the portions of the label that were left on the bottle. Once removed, place the first one over the second to complete the label
• Leave the Label Lifter™ on the label for over 24 hours to allow adhesive to penetrate the paper more fully.
• Completely adhere Label Lifter™ over the entire label. Put hot water inside and also over the top of the label AND the Label Lifters™ for 10-20 seconds or more. Dry and remove. (This method alters the clear glue on the balance of the Label Lifter™. Trim close to the label before applying into your journal.)
• Dramatic Measures: Enjoy a glass of your favourite wine and toss the bottle into the recycling bin!

Q – Who uses Adventures With Wine products?

A – From the beginner wine enthusiast to the most dedicated wine aficionado including:

• Chefs
• Clubs and societies
• Competition organizers
• Culinary schools
• Event organizers
• Restaurants
• Sommeliers
• Wine educators
• Wineries
• Wine/Spirits wholesalers and agents
• Wine schools

Did you know...?

Did you know that not all wines, including red wine, will benefit from cellaring?

Did you know that over chilling wine could mask both faults and characters in wine?

Did you know that not all cheeses compliment wines?

Did you know that the Adventures with… Wine™ Journal Collection includes helpful informative tips like the above three questions?

Did you know that most of our Adventures With Wine products could be customized for corporate and personal gift giving?

**Please Note**If you have some favourite places to shop and would like them to carry Adventures With Wine products, please contact us with their name, address and number.

As our way of saying ‘Thank You’ for your referrals, we would be pleased to send you a complimentary gift of Label Lifters™, a 24 pack, valued at $13.00!